R&G Yamaha R1 Fender Eliminator Kit 2009. This Tail Tidy fits the Yamaha YZF-R1 2009.
Installation Instructions:
Remove rear seat.
Undo the four bolts that hold licence plate to the bike, these are undone from inside the tail unit, as the nuts are captive.
Lower OEM licence plate holder and undo wire connections. Carefully pull the wires out from the under tray.
Fit indicators of your choice to the R&G unit. If using OEM use the two plastic spacers to make them a tight fit. If using after market use the four-infill plates.
Pass the wires back through the bike.
Offer R&G Tail Tidy up to bike and fit using the four OEM bolts with the four nyloc nuts and washers supplied. The bolts may fitted the other way round with the nuts inside the tail unit if preferred
Reconnect the wires to the bike.
Refit the seat
Recommended products list
Customers who bought this product also bought the following products: