Custom LED Yamaha R1 Blaster-X Integrated Tail Light Complete 07-08
Description
This is an integrated tail light retrofit for the stock 2007-2008 YZF-R1 tail light. These ALL NEW units are complete (housing, plug and play wiring and installed CUSTOM LED BLASTER-X board). Circuit board containing 24 Ultra Bright Red LEDs and 24 Ultra Bright Yellow LEDs - compared to only 22 red LEDs on the stock circuit board!
The Custom LED 2007-2008 Yamaha YZF-R1 Integrated LED Tail Light marks the introduction of our new Brake Alert safety feature, strobe Mode and NOW FULLY complete PLUG & PLAY!
Brake Alert automatically provides three quick strobes of light the instant the brakes are applied. This alerts motorists the instant you apply the brakes - possibly saving seconds of reaction time for non alert motorists!
Strobe Mode is a feature that puts the tail light into a devastating strobe cycle that is sure to get anyone's attention. This mode produces insanely bright pulses of light at ultra high frequencies, in alternating patterns across the tail light. Strobe mode is engaged by grounding a control wire, and can be engaged at any time.
Also included is our Blaster-X technology. This technology squeezes the maximum possible illuminance power out of LEDs. The result is a significantly less expensive, yet even more outstanding and effective product than it's predecessors - and widens our advantage over our competitors. It also allows us to utilize less LEDs, thereby maintaining the factory light distribution which was previously not possible.
Just as on the other Custom LED models, the system is designed so that the red LEDs turn off (on one side) when the yellow comes on so that the turn indication is a pure yellow light. The unit automatically flashes between the red and yellow on the side you're turning! The Yellow LEDs are slightly offset as well, creating a dramatic attention grabbing effect.
The engineering is solid and dependable, the looks are unbeatable, and the brightness is incredible! Don't waste your time with half hearted solutions, do it the right way from the start, with Custom LED.
McCoy Motorsports is offering the Blaster-X as a Complete Housing now with board and Lens as easy to install Plug N Play model . The Complete Unit installs just like your factory unit right back into your stock tail section of your bike. You even get to keep your Tail Light.
NOTE: The "BlasterX" effects feature can be activated via a single toggle swith (not included). We suggest one of the billet "MPS" single or dual switches we sell, but any commercially bought toggle switch works great!
Combining the most advanced circuit boards and injected molded OEM style housings (PLUG and PLAY, ready to go), is the best setup AVAILABLE to clean up your 07-08 R1 tail section! UNITS ARE IN STOCK!
Recommended products list
Customers who bought this product also bought the following products:
